|
With the router table completed, for the most part, we started working on the stocks for the VG1-5 rifle. This video takes the stock from a rough sawed pattern to the finished dimensional stock. To complete this task we used two different router bits. The first bit being a bearing guided bit that rides […] Here at gun Lab a terrific day was had. My wife cooked an outstanding meal using her new and almost completed kitchen. There was ham,turkey,stuffing,potatoes,and all the necessary fixings to go with them. Friends and family were her to enjoy the meal. As for myself The day off was perfect. I was able to get […] Another weekend has come and gone. They always seem to go to fast and I never seem to get enough completed before Sunday night arrives. Getting closer to finishing the router table project and on the making the stocks for the VG1-5. I did manage to get the the router lifting table installed. Using […] Another busy weekend here at Gun Lab. I did manage to get some time to work on the router table. The work that was accomplished was on the table top for the router table. The first thing was cut the slots for the biscuits. This was accomplished in both the table top and the oak […] While Axel worked on the pattern for the stock more was accomplished on the router table. All the drawers have been finished and the top has been glued together, marked out and the moulding cut and fitted. I would have finished the moulding up gut my disk sander gave it up. With no new […] This last weekend more work was accomplished on the router table. As with the rest of the project we recycled as much as possible. The molding was added to the cabinet. Starting with a piece of an old oak cabinet that was cut over sized and planed to the proper dimension. With any […] I spent most of this weekend working on my router table. The VG1-5 is coming along and one of the major next steps is the stock for the rifle. I need the router table to do this. I did not have much of an opportunity to work on it last weekend, so it was full […] When we made the first couple of stocks for the VG1-5 we used a fixture to hold the stock. This fixture held the wooden blank that we cut using the bandsaw and then using a hand held router we cut the radius on the out side edge of the stock. This procedure was a little […] |
||
|
Copyright © 2024 GunLab (KnownHost) - All Rights Reserved Powered by WordPress & Atahualpa |
||