|
This post is about making the rear sight button for the FG-42 first model. To give you an idea of the complexity of this part I am adding a picture from “Death From Above” . This is a component break down of the parts for the first model FG-42 rear sight. There is also […] In the last video concerning the FG-42 rear sight base we showed you the lathe work required to complete the first op. This video will show you the rest of the work required to complete the rear sight base on the machining center. Again just a reminder of the part we are making is solid […] We have finally finished the solid model of the Sudanese lower receiver. The total time that has been spent making the solid model is 60 hours. Considering that there were no engineering drawings that were readable and the receiver we had to work with is cut up, I do not feel that is was excessive. […] This post is about machining the stamping die for the bi-pod leg on a first model FG-42. This will be the third stamping die out of a set of 5 dies. It is also one of the more complex of the dies in the set. I will start with the solid model that was drawn […] We have been working on the rear sight for the FG-42 first model. The first picture that is a solid model of the entire sight assembly. The next picture is a picture of the component parts. The part we are currently working on is the base of the sight. So now that you have […] A while back a close friend of mine brought over a parts kit for a Sudanese AR-10. There are no receivers available for this rifle anywhere. However, he did have a cut up receiver. In-addition another friend had sent be some drawings that had been photocopied so many time that done of the dimensions could […] Most of my friends know that I am a little different. Generally when I call or e-mail them to let them know what is going on at gun lab there first comment is always why don’t you just work on one project until you complete it. There is a real good reason that I do […] With there not being any parts available we have to design and make every part. Some times this leads to re-doing a design several times. The firing pin is a case in point. The initial design was to use a H&K 91 firing pin that was turn down to fit the VG1-5. The reason for […] Once again time has gotten away from me. We are in the shop 7 days a week working on the projects and stuff actually gets accomplished. The updates this week will show the good and the bad that we have had in the last couple of weeks. First will be the really bad and that […] With this video we will take you through the machining process for making the FG-42 first model female buttstock stamping die. This is the first of a three part pressing die set for making just one side of the buttstock. The total number of dies to make the buttstock will be 8 to 10 dies […] |
||
|
Copyright © 2026 GunLab (KnownHost) - All Rights Reserved Powered by WordPress & Atahualpa |
||