Why it is necessary to run a test part after changes to the program

A number of changes were made to the Sudanese AR-10 lower receiver. Selector stops were added and a new profiling program was used to allow for a better finish around a few areas of the receiver. Then a second lower was machined out of 6061 to verify the changes.  During the process of machining a few issues were notes. The first is that with the new tool path it left on a thin section of metal.

The magazine release button also changed from an inside cut to and outside cut.

The other issue that was found was that the selector stops were located in the wrong spot.

All the issues have been corrected and checked. Next is to design a logo and write the printing program then start making Sudanese lower semi receivers.