Categories

Machining the FG-42 bi-pod leg female stamping die

This post is about machining the stamping die for the bi-pod leg on a first model FG-42. This will be the third stamping die out of a set of 5 dies. It is also one of the more complex of the dies in the set. I will start with the solid model that was drawn […]

August 14th, 2014 | Category: CNC machining, FG-42, machining, Parts fabrication, solid modeling, stamping dies, Weapons Design | 6 comments

FG-42 first model rear sight

We have been working on the rear sight for the FG-42 first model. The first picture that is a solid model of the entire sight assembly.

The next picture is a picture of the component parts.

The part we are currently working on is the base of the sight.

So now that you have […]

August 9th, 2014 | Category: CNC machining, FG-42, machining, Parts fabrication, solid modeling, Uncategorized, Weapons Design | 11 comments

AR-10 Sudanese contract

A while back a close friend of mine brought over a parts kit for a Sudanese AR-10. There are no receivers available for this rifle anywhere. However, he did have a cut up receiver. In-addition another friend had sent be some drawings that had been photocopied so many time that done of the dimensions could […]

August 7th, 2014 | Category: AR-10, CNC machining, Parts fabrication, solid modeling, Weapons Design | 18 comments
« Newer Entries