Here are a couple of pictures of the router setting on the new table. There are corner supports on every corner top and bottom. The next phase is re-wiring the controllers.
Close up of the support blocks. There are six of then to support the router off of the frame and wood cover. The holes on the end of the block is to allow us to bolt the router to it.
Another view of the support block set up.
All the wiring will be changer and run in cable supports.
Nice looking router and I’m sure it will be very useful for some of your interesting projects.
I would suggest that you make a sheet metal shield to help prevent dust from getting on the linear rails to reduce the amount that will get into the linear bearings. I would also install wipers on the linear bearings.